9 - RocketEV Post EV Installation Checklist - VAN/VIC
  • Post EV Installation Checklist

    Customer Approval Report
  • 3. Was the outlet updated with a 240v with appropriate breaker? Provide supporting image.
  • 4. Was additional conduit run from electrical panel to charger installed? Provide total Amount in ft. and supporting image.

  • 5. Did you have to penetrate any walls for the conduit runs? Provide supporting image.
  • 6. Are any wall contusions sufficiently restored to as-was standard? Provide supporting image.
  • 7. Has the charger been sufficiently mounted on the wall? Provide supporting image.
  • 8. Did you provide instructions on how to use the charger to the Customer? Y/N
  • 9. Did you run a test plug with the EV vehicle prior to leaving and was it functioning as required? - Provide supporting image.
  • Clear
  • My Products

    prevnext( X )

        ChargePoint Home Flex 240v Level 2 Home Charger. Up to 9.6kW



        Flo Home X5. Up to 7.2kW



        Drywall Access Panels . Used to cover any holes made for running wire through home.



        15 Amp Tandem Circuit Breaker Product Image



        40 Amp Circuit Breaker . Required for 7.2kW



        50 Amp Circuit Breaker . Required for 9.6kW



        GFCI External Breaker. Exterior 240v receptacle including GFCI external breaker and NEMA3 exterior rated 50amp receptacle.



        Electrical Sub Panel  Product Image



        6/3 TECK CU Copper Wire x 10M Product Image






        Extended Warranty . - RocketEV Charging Solutions Inc. can provide customers with a yearly maintenance visit at a cost of $300.00. Included in this visit will be the following: - electrician to open exterior cover of charging station to expose interior components and vacuum terminals to ensure no debris has built up. - verify that unit is safely and securely mounted to wall - check that connectors from charging cord are tight, not damaged and free of debris - check that charging cord itself has not been frayed or damaged - verify voltage on terminals is sufficient - tighten terminals to manufactures specs - open house panel and confirm there is no oxidation at breaker terminals - provide RocketEV Certificate of Inspection and report upon completion *****if damages are found with equipment then additional charges will apply*****



        Pre-Installation Check. Cost for electrician to inspect installation. Billed only when installation does not get approved by customer.

        Program & Admin Fee Product Image



        Subtotal $0.00 CAD$0.00CADTax $0.00 CAD$0.00CADTotal $0.00 CAD$0.00CAD

        Credit Card

      • Should be Empty: